For example, if you have your Ducts category turned off in your Revit project via ‘VG’ these will also be turned off in Navisworks when exporting to an. Items which are turned off in Visibility/Graphic Overrides will be applied in your Navis view. However, if you apply your hide / isolate elements to the view, Navisworks will remember these settings and omit any elements hidden and applied. Items which are hidden but not applied to the view will still be visible in Navisworks. If your model is on ‘Course’ detail, elements such as pipes will show up as lines rather than 3D pipes as you would see in Revit. When exporting your Revit model to Navisworks, pay attention to the detail level which is set. Compare the values you are getting when picking the same point on both the Arch & Struc models.There are various ‘view settings’ which are transferred through from Revit into Navisworks that you may not be aware of: Under Manage Tab, click coordinates then click Report Shared Coordinates. Both of their drop down menus don't have an options that pull up a screen to tell me the Coordinates or the Position.įri, at 8:03:14 PM | Origin Issues when Exporting to Navisworks How do i check the coordinates and the Position. Sorry if this is a basic question, i just haven't had to change origins before. It is not when you linked struc with arch files and match them on screen.įri, at 7:50:08 PM | Origin Issues when Exporting to Navisworks Under Manage tab, verify that both files have the same location, coordinates & position. Fri, at 7:39:01 PM | Origin Issues when Exporting to Navisworks
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |